GIMP – How to use oilify and Emboss effect to make rubber material?

I am trying to make a plain looking rubber material, slightly polished as shown in the left image. What I tried is in the right image, using these steps:

  1. Used Oil brush to make basic shape.
  2. Applied RGB noise.
  3. Applied Embroidery/Furr filter.
  4. I also tried the emboss effect; it did not work.

How can I make the image look like moulded rubber material?

Left Right

Answer

This is similar to the answer give by Bestorio, in that I’ve also used the Lighting Effects filter, but with some differences.

Here I applied correlated RGB noise to a 50% grey layer above a red filled layer, with the blending mode of the noise layer set to hard light, then I scaled the noise layer to make the particles bigger, then created a new layer from visible and blurred it slightly, then applied the lighting effects.

Here I show the blurred noise, then the lighting effects applied.

enter image description here

Here are the settings I used for the Lighting Effects, although one could adjust these as required.

enter image description here

Finally, you could use an image of a paint splash as a layer mask to reveal the texture.

enter image description here

Attribution
Source : Link , Question Author : LaraFlow , Answer Author : Billy Kerr

Leave a Comment