How to add a break to an ellipse and have the exposed ends look rounded instead of directly cut off

I have a drawing with three concentric circles (ellipse tool), as shown in the attached image. I want to add a break to one of the internal circles, and have the exposed ends look rounded instead of just flatly cutoff. Relative Illustrator beginner here. Whats the best way to do this? Each circle is on its own layer on the board. Using Illustrator CC, latest version.

enter image description here

Answer

You could drop some guides, and using the Add Anchor Point tool (+), add two anchor points to the circle to intersect with the guides.

Select and delete the two segments using the Direct Selection tool (A)

Set Round Caps in the Stroke panel

enter image description here

Another possibility is to draw a shape on top, then use the Shape Builder tool while holding down Alt to delete a segment

enter image description here

Attribution
Source : Link , Question Author : optionsix , Answer Author : Billy Kerr

Leave a Comment