How to convert old scanned documents into black and white

I have some old documents that have been scanned, and I want to convert them to black and white. Content should be always black, and background white:

enter image description here

I use Photoshop.


If you have control over the scanning, or can get them rescanned, increase the contrast setting in the scan and set the black point at the darkest bit of text you can find. That would make the steps below easier. If not, read on…

Here’s part of a fairly typical old document scan:

Scan of old document

The details will be different depending on the document (this has somewhat higher contrast than your sample, for example) but the broad outline will be the same.

  • Convert to grayscale using a Black and White adjustment layer. Use the Targeted Adjustment Tool (“Scrubby”) in the adjustment layer panel to lighten the background (scrub to the right) and darken the text (scrub to the left) as much as you can.

Black and White Adjustment layer

Notice that the yellows slider is far to the right, lightening the yellowish background. I was able to darken the text only a little.

  • Use a Levels adjustment layer to increase the contrast.

Levels adjustment

This gets you 95% of the way there. A scanned document typically has a histogram with a large lump toward the right (the paper) and a smaller lump toward the left (text). You’ll have to experiment with your documents to find the right settings.

From this point, you can duplicate the image, flatten the duplicate, and use your regular Photoshop retouching tools to clean up the remainder.

Source : Link , Question Author : user2496077 , Answer Author : Alan Gilbertson

Leave a Comment